Maintaining a garden is not easy, and there are some faults and defects that keep happening then and now. Such a problem is the leakage of the garden hose, which leads to the spilling and wastage of water in the garden, making it an absolute mess. But you do not need to splurge money for it’s repair and it can be done by yourself just by following a few steps.
Follow these easy steps suggested by us to fix a garden hose and get it done within a few minutes, without investing any extra costs.
6 Steps to Fix Garden Hose:
Detect the leakage
Going on a whole hunt is very important before you start working on fixing the garden hose. Some leakages are big enough and can be easily detected, but some are very small and might miss your sight. Different holes can be located at different places of the hose, and each has a different solution. So, you cannot start with the fix, till you do not end up detecting the leakage in the hose.
Fix each joint
There might be only one leakage, or there can be multiple leakages too in the garden hose. If you want to fix the hose completely, then it is important to repair every leakage. Begin with detaching the hose from other hoses and devices and start lubing the edges with the petroleum jelly. The process of detaching and attaching the hose will ensure fewer leaks. You can also use a rubber washer if the previous step seems to be too tiring. Such rubber washers can be easily availed of at any hardware store or any gardening store. These washers must be inserted in the female end of the hose and joined to any hose or device, to prevent leakage.
Also Read:
Apply rubber cement
If there is any tear or puncture in the garden hose, then one must use rubber cement to repair it. Take a dry paper towel and rub off the hose area where the leakage is located. For bigger leakages and holes, try using a piece of dowel to clear the inside part of the hose, wrapped around a paper towel. After doing so, apply some rubber cement around the hole, but make sure it does not get inside the hose. If the cement gets inside the hosepipe, then the water might get clogged inside, increase the water pressure, and lead to the burst of the pipe.
Keep a kit ready
To repair a garden hose, one must always keep a puncture repair kit ready, which is commonly found in the cycle repair shops. However, it is advised to read the given instructions properly on the kit properly before you use them otherwise, it might lead to accidents. Once you have followed the previous step and dried the hose coating completely, lay a small sheet of solid rubber. Cut the piece according to the leakage and attach the rubber sheet with glue on the area and dry it, to ensure more extended usage.
Get a coupling for tears
The fixation of the garden hose is indeed a tiresome affair, and doing it, again and again, can be tough too. So, it is advised to get a coupling, which can help you to repair the severe tears. You can avail it from a hardware store, which can be used to cut down the portion of leakage from the whole hose, and then again, rejoin it by using a rubber sheet. However, you need to be quite cautious while using a coupling. Make sure you shut off the water to the hose and detach the leaked portion from it with the linkage.
Set back everything in place
Once you’re done with the previous step, you have reached the final step, and now, it is time for you to test the water flow through the hose and keep everything back in the place.
That’s all friends. Hope this guide help you to fix garden hose. Try this method and comment down your experience below. If you found this article useful then share it with friends.
